![]() In a nutshell, you need to insert and remove the key from the ignition twice, close and open the door twice, and repeat this several times. I'm a huge Toyota fan, but I must say their key fob reprogramming procedure is a little ridiculous. Once you hear the locks cycle, your key fob should be programmed to your GM. This could take up to 30 seconds, so be patient. To program your keyless-entry remote, press and hold the "LOCK" and "UNLOCK" buttons on the key fob simultaneously until the locks cycle once more. You are now in programming mode! Step 5: Hold Down the “UNLOCK” and “LOCK” Button on Your Fob Within a few seconds, you will hear the locks cycle. Note we are not starting the vehicle, only turning the key one notch to power the electrical systems.Ĭycle the ignition twice by turning the key "ON"-"OFF"-"ON"-"OFF." Step 4: Release the “UNLOCK” Button on the Driver Side DoorĪfter cycling the ignition twice, release the "UNLOCK" button. ![]() Now we're going to cycle the ignition two times. While holding down the "UNLOCK" button on your door, insert your key into the ignition. Push down and hold the "unlock" button on your driver's side door-not to be confused with the unlock button on the fob.Ĭontinue holding down the unlock button. Step 2: Hold the "Unlock" Button on the Driver Side Door ![]() You'll need your car key and any fobs that you wish to program. Start by getting into your vehicle on the driver's side and close all the doors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |